FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
8. CONNECTION TO SETTING AND DISPLAY UNIT
271
The detachable LCD/MDI Type B is an LCD/MDI unit with an 8.4inch
LCD/MDI housed in a portable case. The unit has the following features:
D The detachable LCD/MDI Type B is much thinner than the
conventional detachable LCD/MDI and weighs about a half of the
conventional one.
D The detachable LCD/MDI Type B allows both display link (CRT link)
connection and video signal/MDI signal connection.
D While the CNC is on, the detachable LCD/MDI Type B can be
connected (detachable).
D The input power supply voltage is 100 to 240 VAC.
Before connecting this detachable LCD/MDI Type B (called the
detachable LCD/MDI hereinafter), check the CNC interface. The cabling
method differs depending on the interface. In addition, the selection
switch SW1 located on the top of the detachable LCD/MDI needs to be
set. The detachable LCD/MDI is connected to the Power Mate i via the
display link.
1) Connection via the display link
CNC
Twocable connection
Cabinet
100 to 240VAC
power supply
Display link
interface
Relay
panel
Power
supply
Detachable
LCD/MDI
Set selection
switch SW1 to B.
Display link
2) Connection via video and MDI signals
Threecable connection
Cabinet
100 to 240VAC
power supply
MDI signal
Video signal
Relay
panel
Power
supply
Detachable
LCD/MDI
Set selection
switch SW1 to A.
MDI signal
Video signal
CNC
8.6
DETACHABLE
LCD/MDI TYPE B

Leave a Reply

Your email address will not be published. Required fields are marked *