FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

8. CONNECTION TO SETTING AND DISPLAY UNIT
B63173EN/03
272
NOTE
1 The customer needs to prepare the cable between the
detachable LCD/MDI and relay panel, the cable between
the power supply and relay panel, the cable between the
CNC and relay panel, and the relay panel.
2 Selection switch SW1 specifies whether the display link or
video and MDI signals are used for connection.
Display 8.4 TFT, 40 characters x 16 lines
Outside
dimensions
445 (W) 229 (H) 122 (D)
(not including interunit connection cables)
Weight 3.5 kg (not including interunit connection cables)
Power supply AC100V to 240V
Current capacity 0.5 A (on 100 VAC), 0.25 A (on 200 VAC)
Interface One channel for the display link (CRT link) or one channel
for the video/MDI signals, selected by the switch on the unit
Keyboard Small type Mseries English keys
Specification
drawing number
Unit: A02B0166C291#R (not including interunit
connection cables)
Nameplate: A02B0166J103 (FANUC)
NOTE
1 The display link cannot be used for connection to more than
one CNC (the CRT sharing function).
2 Protruding portions on the top and side planes are not
included in the outside dimensions.
3 This unit is not approved for the CE marking.
Ambient
temperature
Operating: 0°C to 45°C, transportation and storage: 20°C
to 60°C
Relative humidity 30% to 95% (no condensation)
Vibration Operating: 0.5 G or less, transportation and storage: 1.0 G
or less
Contaminant Avoid direct exposure to contaminants (such as dust,
coolant, organic solvent, acid, corrosive gas, and salt). See
NOTE.
(Non)ionized
radiation
Avoid direct exposure to radiation (such as microwave,
ultraviolet ray, laser beam, and Xray).
Elevation Operating: 1000 m or less, transportation and storage:
1200 m or less
8.6.1
Specifications
8.6.2
Environmental
Conditions

Leave a Reply

Your email address will not be published. Required fields are marked *