FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

8. CONNECTION TO SETTING AND DISPLAY UNIT
B63173EN/03
274
(1)Detach power cable J169 from connector CPA on the relay panel.
(2)Detach display link cable J182 from connector CA72 on the relay
panel.
NOTE
1 Put the FANUCspecified label near connector CA72 on the
relay panel to indicate that the selection switch SW1 is to be
set to B. (See Subsection 8.6.9.)
2 Cable J171 is not connected to the relay panel. Detach the
cable from connector CA62 of the detachable LCD/MDI
beforehand, or take appropriate measures not to expose
the connector CA73 directly to contaminants. (In an
environment where strong noise is generated, the cable
J171 can function as an antenna receiving noise.)
3 After cabling, you may set selection switch SW1.
4 When you want to perform a special operation at poweron
such as a memory all clear operation, connect the
detachable LCD/MDI, turn on the power to the CNC, then
perform the special operation.
5 When the cable is detached and attached directly from/to
connector JD41 of the Power Mate i, enough working space
is required.
Disconnection method

Leave a Reply

Your email address will not be published. Required fields are marked *