FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
8. CONNECTION TO SETTING AND DISPLAY UNIT
315
NGOK
<4> Attach the right and left sides of the protection sheet while
pushing out air between the touch panel and protection sheet.
D With part of the protection sheet kept stuck to the touch
panel, do not attempt to correct the position of the protection
sheet by pulling the sheet.
<5> Press the adhesive parts of the four sides, and attach the entire
sheet completely.
D Check that the four corners and four sides of the protection
sheet do not float.
3) Checks after replacement
<1> Check that there is no wrinkle on the surface of the protection
sheet.
<2> After poweron, check that there is no touch panel portion kept
pressed.
<3> Press the touch panel, and check that correct operation takes
place.

Leave a Reply

Your email address will not be published. Required fields are marked *