FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
9. CONNECTION TO SERVO OR SPINDLE
333
CAUTION
To mount and remove the unit, the screwdriver must be
inserted obliquely. An adequate maintenance area is,
therefore, required on both sides of the unit.
As a rough guide, if the depth of the adjacent unit is equal
to or less than that of the unit to be mounted, leave a space
of about 20 mm between the units. If the depth of the
adjacent unit is greater than the unit to be mounted, leave
a space of about 70 mm between the units.
When mounting the unit near the side of the cabinet, leave
a space of about 70 mm between the unit and the side of the
cabinet.
Maintenance areas around the
separate detector interface unit

Leave a Reply

Your email address will not be published. Required fields are marked *