FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
9. CONNECTION TO SERVO OR SPINDLE
353
The ready signal input and alarm signal input from the analog servo
interface are 24VDC signals.
1) Configuration when a builtin pulse encoder is used
COP10M
JV1nL
COP10L
J157
Higher unit
on FSSB
Lower unit
on FSSB
Analog
servo
interface unit
Analog servo
amplifier
Pulse
encoder
Analog
servo motor
2) Configuration when a separate detector is used
COP10M
JA4L
JV1nL
COP10L
JF10nL
J158
J37
J156A/J156B
Higher unit
on FSSB
Lower unit
on FSSB
Analog servo
amplifier
Pulse
encoder
Analog
servo motor
Battery for
separate
detector
Separate
detector
1) Cable J156A/J156B
See 2) and 3) of Subsection 17.4.2.
2) Cable J37
See 4) in Subsection 17.4.2.
3) Cable J157
Cable J157 is used to connect an analog servo interface unit (JV1nL)
and analog servo amplifier.
9.5.5
Connection of Analog
Servo Interface Type M
9.5.5.1
System configuration
9.5.5.2
Connection details

Leave a Reply

Your email address will not be published. Required fields are marked *