FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

9. CONNECTION TO SERVO OR SPINDLE
B63173EN/03
368
Power Mate i
CA54
Servo
check
board
adaptor
Servo check board#1
Servo check board#2
Servo check board#3
Servo check board#4
Connect the cable of the servo check board adaptor to connector CA54 of
the Power Mate i. CA54 is located in the basic unit.
1 Turn off the power to the Power Mate i.
2 Remove the fan unit, referring to Section 2.5.1, Removing the fan
unit in the Power Mate i Maintenance Manual.
3 Pull the base printed circuit board by about 1/3 of its depth (until
connector CA54 is visible), referring to Section 2.6.1, Inserting and
removing the base printed circuit board in the Power Mate i
Maintenance Manual.
4 Pass the cable of the servo check board adaptor through the hole
located in the lower part of the basic unit (above the faston pin) and
connect it to connector CA54.
5 Return the base printed circuit board to its original position.
6 Mount the fan unit, referring to Section 2.5.2, Mounting the fan unit
in the Power Mate i Maintenance Manual.
7 Connect a servo check board to the servo check board adaptor. Support
the servo check board so that its weight does not pull it out its the
connector.
NOTE
On the base printed circuit board, SRAM with battery
backup is mounted. When connecting the cable, do not pull
the base printed circuit board outward more than necessary
so that other objects do not come into contact with the
portions of the base printed circuit board other than the face
plate. Back up the SRAM contents to the builtin FROM of
the Power Mate i before cable connection so that if the
SRAM contents should be damaged, they can be restored
soon.
When the use of the servo check board is completed, disconnect the cable
of the servo check board adaptor from the Power Mate i, by reversing the
above procedure.
9.6
CONNECTING
SERVO CHECK
BOARDS
9.6.1
Connection Procedure

Leave a Reply

Your email address will not be published. Required fields are marked *