FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

10. CONNECTION TO PERIPHERALS
B63173EN/03
378
(5)Connecting the RS232C interface with an I/O device
NC
SD
RD
RS
CS
ER
DR
CD
SG
FG
SD
RD
RS
CS
ER
DR
CD
SG
FG
I/O device
1) Two RS232C channels can be connected to serial port JD42 of the
Power Mate i. Normally, two channels are used so that the second
channel can be used for purposes of maintenance with a notebook
personal computer. When only one channel is used, a separate
setup/display device for maintaining the Power Mate i is required.
2) When two channels are connected to the serial port, the following
devices may be connected to channel 1:
S I/O device such as the Handy File
S RS232C device controlled by a macro executor or C executor user
program
When a userprogramcontrolled RS232C device is connected,
I/O devices such as the Handy File cannot be used. In this case, data
must be saved and restored using a memory card or a notebook
personal computer connected to channel 2.
3) When two channels are connected to the serial port, the following is
connected to channel 2:
S Notebook personal computer (FAPT LADDERII, DPL/MDI
operation package)
Basically, channel 2 should be kept connectable to a notebook
personal computer. (FANUC service uses the notebook personal
computer for maintenance purposes.)
NOTE
No control line is provided for channel 2. Therefore, only a
device that can be controlled using DC codes rather than a
control line can be connected to channel 2.
4) When one channel is connected to the serial port, the following devices
may be connected:
S I/O device such as the Handy File
10.1.2
RS232C Serial Port
Specifications

Leave a Reply

Your email address will not be published. Required fields are marked *