FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
10. CONNECTION TO PERIPHERALS
379
S RS232C device controlled by a macro executor or C executor user
program
When a userprogramcontrolled RS232C device is connected,
I/O devices such as the Handy File cannot be used. In this case, data
must be saved and restored using a memory card.
For singlechannel connection, the device shown below cannot be
used. To use the following, connect two channels to the serial port:
S Notebook personal computer (FAPTLADDERII, DPL/MDI
operation package)
5) For FANUCs 24V type I/O devices, 24VDC power must be output
to the relay connector. Also for channel 2, output 24VDC power for
use in the future.
6) A notebook personal computer (FAPTLADDERII, DPL/MDI
operation package) is connected with the power to the Power Mate i
on (detachable). For this reason, the 0V line of the Power Mate i and
the 0V line of the notebook personal computer must be connected
first. For details, see Subsection 10.1.3. Make channel 1, which is not
connected to a notebook personal computer, also detachable for future
use.
NOTE
When the notebook personal computer is connected to the
Power Mate i in detachable mode, the power to the
notebook personal computer must have been turned off.

Leave a Reply

Your email address will not be published. Required fields are marked *