FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

10. CONNECTION TO PERIPHERALS
B63173EN/03
386
1
FG SD RD SG
2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25
1 (RDA)
2 (0V)
3 (DRA)
4 (0V)
11 (SDA)
12 (0V)
13 (ERA)
14 (0V)
5 (CSA)
6 (0V)
7 (CDA)
8 0V
15 (RSA)
16 (0V)
17 SDB
18 0V
9 RDB 19
Power Mate
JD42
(PCRE20MD)
10 20
FG
PC
Cableside connector
Connector: DBM25P (Japan Aviation Electronic Inc., Ltd.)
Lock metal: DBC2J9 (Japan Aviation Electronic Inc., Ltd.)
Relay cable
Relaying connector
Connector: DBM25S (Japan
Aviation Electronic Inc., Ltd.)
Lock metal: D20418J9
(Japan Aviation Electronic
Inc., Ltd.)
Relay connector signal layout
PC side cable
NOTE
1 Machine tool builder shall furnish relay connector and relay
cable.
2 Use a totally shielded cable for the signal cable.
Recommended cable specification:
A66L00010284#10P (#28AWG × 10 pairs)
3 Open all terminals other than illustrated.
4 Connect the Power Mate to 0V of the notebook personal
computer first so that the Power Mate can be connected to
and disconnected (detached) from the notebook personal
computer while the Power Mate is turned on.
10.1.6
Connection by the
Notebook Personal
Computer (Channel 2)

Leave a Reply

Your email address will not be published. Required fields are marked *