FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
10. CONNECTION TO PERIPHERALS
407
Recommended cable: A66L00010284#10P (#28AWG 10 pairs,
common shield)
<Hitachi Cable, Ltd., Oki Electric Cable Co., Ltd.>
Recommended connector on the cable side:
PCRE20FS or PCRE20FA, housing:
PCRV20LA <Honda Tsushin>
FANUC purchase drawing number:
A20B0259K863 (cable length: 500 mm)
A02B0259K864 (cable length: 5 m)
A02B0259K865 (cable length: 10 m)
NOTE
1 Do not change the combination of the wires of twisted pairs.
2 Do not make any connection other than the above.
3 The maximum cable length between the Power Mate iH
and display link adapter is 500 mm.
Jd41
Power Mate i
50m
J175
JD41B JD41A
JD41
J175
J175 J175 J175
Jd41
Power Mate i
Jd41
Power Mate i
Display link
adapter
Display link
adapter
Display link ter-
minating unit
Display link
adapter
Display link adapter
Display link ter-
minating unit
Display link
adapter
(1)The same restrictions as on J45 of the CRT/MDI interface described
in Section 8.1 are imposed on cable J175. In particular, pay attention
to the cable length between the Power Mate iH and display link
adapter. For cable connection, see Subsection 10.6.2.
(2)The maximum cable length is 50 m (the total length of cables J175 that
interconnect the display link adapters).
(3)The multiaxis synchronization signal is terminated by the display link
terminating units at both ends.
10.6.3
Connection When a
Setup/Display Device
Using the Display Link
Interface is Not Used

Leave a Reply

Your email address will not be published. Required fields are marked *