FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

10. CONNECTION TO PERIPHERALS
B63173EN/03
408
1) Connection diagram
Jd41
Power Mate i
Jd41
Power Mate i
Jd41
Power Mate i
Display link adapter
JD41B JD41A
JD41
Display link adapter
JD41B JD41A
JD41
Display link adapter
JD41B JD41A
JD41
J177 J177 J177
J175 J175
J179 J179 J179
J178
J180
J178
J180
J178
J180
Display link
terminating
unit
Display link
terminating
unit
Setup/display
device
Setup/display
device
Setup/display
device
Connector
panel
Connector
panel
Connector
panel
(1)The connector panels are to be created by the customer.
(2)The same restrictions as on J45 of the CRT/MDI interface
described in Section 8.1 are imposed on cable J175.
The maximum cable length is 50 m (the total length of cables J175
that interconnect the display link adapters).
For cable connection, see Subsection 10.6.2.
(3)Cables J178 to J180 are not available from FANUC.
(4)The cable length from the Power Mate iH to connector panel to
display link adapter should be as short as possible (500 mm
maximum).
(5)The restrictions on the display link interface are the same as those
described in Section 8.1. Note that, however, the maximum cable
length, 50 m, cannot be exceeded. (J177 + J178 + J180)
(6)The display link interface signal is terminated by the setup/display
device (including a terminating resistor) and each Power Mate iH.
When the setup/display device is detached, the display link
interface signal need not be terminated.
(7)The multiaxis synchronization signal is terminated by the display
link terminating units at both ends.
10.6.4
When a Setup/Display
Device Using the
Display Link Interface
is Used among the
Power Mate iH Units
in a Detachable Manner

Leave a Reply

Your email address will not be published. Required fields are marked *