FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
10. CONNECTION TO PERIPHERALS
409
(8)The handy operators panel is connected in the same way as the
above though the handy operators panel does not use the display
link interface.
JD13(01)
JD13(02)
JD13(03)
JD13(04)
JD13(11)
JD13(02)
0V
0V
0V
0V
TXD
*TXD
RXD
*RXD
0V
0V
RXD
*RXD
TXD
*TXD
0V
0V
JD41(01)
JD41(02)
JD41(01)
JD41(02)
JD41(11)
JD41(12)
JD41(05)
JD41(06)
JD41(07)
JD41(08)
JD41(17)
JD41(18)
JD41(11)
JD41(12)
JD41(05)
JD41(06)
JD41(07)
JD41(08)
JD41(17)
JD41(18)
Power Mate iH
0V
0V
0V
0V
RXD
*RXD
TXD
*TXD
CRS10(01)
CRS10(02)
CRS10(03)
CRS10(04)
CRS10(19)
CRS10(20)
CRS10(15)
CRS10(16)
ATCH1
ATCH2
ATCH1
ATCH2
RXALM
*RXALM
TXALM
*TXALM
COMMA
*COMMA
0V
0V
RXALM
*RXALM
TXALM
*TXALM
COMMA
*COMMA
CRT/MDI, etc.
Handy operators panel
Connection
panel
Display link
adapter
Connector
panel
NOTE
1 The connector panel is to be prepared by the customer.
2 In the above diagram, cabling of JD41A and JD41B among
the display link adapters is omitted.
3 In the above diagram, the terminating wiring at JD41 of the
Power Mate iH is omitted.
4 When the handy operators panel is used, the ATCH1 and
ATCH2 signals must be connected to the Power Mate iH
via the connection panel and connector panel. In addition,
signals (EMGTP, EMGEN, EMGDM, +24 V, and FG) input
to the handy operators panel for purposes of other than
communication must be wired. See Subsection 8.7.3 and
the above connection diagram.

Leave a Reply

Your email address will not be published. Required fields are marked *