FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
C. 20PIN INTERFACE CONNECTORS
AND CABLES
APPENDIX
467
Cableside connectors consist of a connector main body and housing.
The models listed below are available. Those connectors not marked with
an asterisk are currently being massproduced as manufacturers standard
models. Those marked with an asterisk are produced according to custom
specifications by FANUC.
Table C.2 Cableside connectors
Use Type
Manufac-
turer
Connector
model
Housing model
Applicable cable
outside diameter
Honda PCRE20FA PCRV20LA*
f6 mm
(f5.7 to 6.5)
FI3020S* FI20CV2*
f6.2 mm
(f5.5 to 6.5)
Strand wire
pressmoun
t type
Hirose
FI3020S*
FI20CV7*
(Note)
f6.2 mm
(f5.5 to 6.5)
t type
Fujitsu
FCN247J020
G/E
FCN240C020
Y/S*
f5.8 mm
(f5.5 to 6.5)
General use
Molex 526222011* 526242015*
f6.2 mm
(f5.9 to 6.5)
Honda PCRE20FS PCRV20LA*
f6 mm
(f5.7 to 6.5)
Cableside
connector
Soldering
FI4020S* FI20CV2*
f6.2 mm
(f5.5 to 6.5)
type
Hirose
FI40B20S*
(FI40A20S*)
FI20CV5*
f9.2 mm
(f8.9 to 9.5)
FI40B20S* FI20CV6*
f10.25 mm
(f9.5 to 11.0)
Honda PCRE20FS PCRV20LA*
f6 mm
(f5.7 to 6.5)
For pulse coder,
coaxial cable,
Soldering
FI40B2015S*
(FI402015S*)
FI20CV*
f8.5 mm
(f8.0 to 9.0)
linear scale,
manual pulse
generator, etc.
type
Hirose
FI40B20S*
(FI40A20S*)
FI20CV5*
f9.2 mm
(f8.9 to 9.5)
FI40B20S* FI20CV6*
f10.25 mm
(f9.5 to 11.0)
NOTE
Low screwlock housing (Can not used in Power Mate i.)
C.2
CABLESIDE
CONNECTORS

Leave a Reply

Your email address will not be published. Required fields are marked *