FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

C. 20PIN INTERFACE CONNECTORS
AND CABLES
B63173EN/03
APPENDIX
468
D Strand wire pressmount connector:
With this connector, #28AWG wires are pressconnected to each pin
at the same time. The cost of producing a cable/connector assembly
with this connector model is much lower than with connectors
designed for crimping or soldering.
D Solder type connectors
The table below gives further details of solder type connectors and the
housings.
Connector model
(manufacturer)
Description
PCRE20FS (Honda)
For general signal applications. Suitable for assembly
of a small number of cables or for onsite cable
assembly
FI4020S (Hirose) Equivalent to the Honda PCRE20FS
FI40B20S (Hirose)
(former FI40A20S)
This connector has as many pins as the FI4020S and
a wider space between soldering portions. This
results in increased work efficiency in soldering. A
thick wire can be soldered. In comparison with the
conventional FI40A20S, with which a wire of up to
about #20AWG can be soldered, this connector has
higher pin strength and allows wires of up to about
#17AWG to be soldered. When a thick wire such as
#17AWG is used, it is recommended that a strong
housing such as FI20CV6 be used.
FI40B2015S (Hirose)
(former FI402015S)
The number of pins has been thinned out to expand a
space between soldering portions. This connector
has higher pin strength than the conventional
FI402015S. If the outside diameter of a cable does
not exceed 8.5 mm, thick wires of up to about #17AWG
can be soldered. This connector cannot be used with
the position coder interface of the i series.
Housing
(manufacturer)
Description
FI20CV5 (Hirose)
Plastic housing recommended for the FI40B20S
Applicable cable outside diameter: 9.2 mm
FI20CV6 (Hirose)
Diecast metal housing developed for the FI40B20S
Applicable cable outside diameter: 10.25 mm
(FI20CV6 is a diecast metal case.)
For the solder type connectors of Hirose Electric and the housings, the
combinations indicated below are possible as well as the combinations
indicated in Table C.2. Use a cable of which outside diameter matches
the limitation of the housing.
Connector model
FI40B2015S
(formerly FI402015S)
FI4020S
FI40B20S
(formerly FI40A20S)
Housing model
(applicable cable outside diameter)
FI20CV (8.5 mm) No other diameters
FI20CV2 (f6.2mm)
FI20CV5 (f9.2mm)
FI20CV6 (f10.25mm)
Mutually
applicable
Supplementary
description of
cableside connectors

Leave a Reply

Your email address will not be published. Required fields are marked *