FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
C. 20PIN INTERFACE CONNECTORS
AND CABLES
APPENDIX
471
Machine tool builders are required to manufacture or procure the
materials for the cable assemblies to be used with their products. FANUC
recommends the following materials as being suitable for interface
connectors. Individual machine tool builders are encouraged to contact
each cable manufacturer for themselves, as required.
Table C.5 Recommended materials for cable assemblies
Material Use Constitution FANUC specification
number
Manufacturer Remark
10pair cable General use 0.08 mm
2
10 pairs A66L00010284#10P Hitachi Cable, Ltd.
Oki Electric Cable
Co., Ltd.
5conductor
coaxial cable
CRT interface
(longdistance)
5conductor coaxial A66L00010371 Hitachi Cable, Ltd. 50 m or less
12conductor
composite
cable (Note)
Pulse coder 0.5 mm
2
6 conductors
0.18 mm
2
3 pairs
A66L00010286 Hitachi Cable, Ltd.
Oki Electric Cable
Co., Ltd.
20 m or less
Linear scale 0.75 mm
2
6 conductors
0.18 mm
2
3 pairs
A66L00010402 Oki Electric Cable
Co., Ltd.
30 m or less
Usable on
movable parts
Manual pulse
generator
1.25 mm
2
6 conductors
0.18 mm
2
3 pairs
A66L00010403 Oki Electric Cable
Co., Ltd.
50 m or less
Usable on
movable parts
NOTE
For a pulse coder, scale, manual pulse generator, or other
unit using +5 V power, select cable wires considering the
voltage drop due to the cable resistance.
C.5
MATERIALS FOR
CABLE ASSEMBLIES

Leave a Reply

Your email address will not be published. Required fields are marked *