FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

E. INTERFACE CABLE
B63173EN/03
APPENDIX
490
E
INTERFACE CABLE
Cables
Cable No. Name and connection Maximum length (m)
J22 I/O Link cable between the JD1A1 and JD1B Electric: 10m
Optical: 200m
J24 Power cable between the 24 V power supply and I/O card or the I/O unitA
J30 Power cable between the 24 V power supply and Power Mate or CRT/MDI unit
J38 S-analog output cable between the JA11 and analog spindle 50
J39 Serial spindle cable between the JA11 and optical I/O Link adaptor 2
J39 Serial spindle cable between the JA11 and spindle amplifier 50
J40 Position coder cable between the JA46 and position coder 50
J41 Manual pulse cable between the JA47 and manual pulse generator 50
J86 Builtin I/O cable (34pins) between CB155 and power magnetics cabinet 50
J87 Builtin I/O cable (50pins) between CB156 and power magnetics cabinet 50
J88 DI/DO cable between the CM51 and power magnetics cabinet 50
J89 DI/DO cable between the CM52 and power magnetics cabinet 50
J90 DI/DO cable between the CMB3 and power magnetics cabinet 50
J91 DI/DO cable between the CMB4 and power magnetics cabinet 50
J142 CRT/MDI cable between the JD41 and JD13 50
J146 Punch panel cable between the JD42 and an I/O unit relay connector 50
J147 External pulse generator cable between JA46 and external pulse generator 50
NOTE
Each maximum allowable cable length relates to the use of
the cable for an interface signal. For some cables (such as
that for a pulse coder) that contain a power cable, however,
an additional limit, based on a drop in the supply voltage, is
imposed.

Leave a Reply

Your email address will not be published. Required fields are marked *