FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
F. MEMORY CARD INTERFACE
APPENDIX
495
The memory card interface at the front of the main unit can be used for
data input/output to and from the Power Mate. This appendix describes
the specifications of the usable memory cards and provides notes on their
use.
SRAM cards that conform to any of the following standards can be used:
D TYPE 1 or TYPE2 4.0 or later, as defined by the Japan Electronic
Industry Development Association (JEIDA)
D TYPE1 or TYPE2 2.0 or later, as defined by the Personal Computer
Memory Card International Association (PCMCIA)
D PC Card Standard
SRAM cards operable only on 3.3 V cannot be used because they cannot
be physically inserted.
FANUC has checked the operation of the following FANUCdesignated
SRAM cards:
1MB SRAM card Fujitsu Media Device MB98A9102320
2MB SRAM card Fujitsu Media Device MB98A9112320
NOTE
Since the SRAM memory card holds a backup copy of
battery data, the memory card cannot be used for backing
up the SRAM data of the Power Mate i.
Series 2 flash memory cards from Intel Corp. (or equivalents) can be used.
As with SRAM cards, however, flash memory cards operable only on 3.3
V cannot be used because they cannot be physically inserted. Flash
memory cards using nonIntel flash memory as a builtin chip cannot be
used. When the flash memory card is formatted and written on a personal
computer, however, it may prove possible to read the card.
FANUC has checked the operation of the following FANUCdesignated
flash memory card:
4MB flash memory card Intel IMC004FLSA
NOTE
1 The 265KB, 512KB, and 1MB flash memory cards usable
with the Power Mate D do not work with the Power Mate i.
2 The 4MB flash memory card that is compatible with the
Power Mate H can also be used with the Power Mate i.
F.1
Power Mate i MAIN
BODY
Overview
SRAM cards
Flash memory cards

Leave a Reply

Your email address will not be published. Required fields are marked *