FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
F. MEMORY CARD INTERFACE
APPENDIX
499
1. Overview
The PCMCIA card interface of FANUC Power Mate iD/H allows
data input/output via a flash ATA card (operating on 5 V).
The flash ATA card has the advantage that data can be input and output
with a personal computer including the PCMCIA interface without a
special PC card writer.
2. Supported software editions
The supported software editions are as follows:
Model Series Edition
System software
Power Mate iD 88E0 09 or later
Power Mate iH
88F0 08 or later
88F1 01 or later
Boot software Power Mate iD/H 881I 05 or later
3 Flash ATA card specifications
A flash ATA card to be used must meet the following standards and
types.
Note that all flash ATA cards that conform to the indicated standards
do not always ensure operation.
For the cards FANUC has checked the card operation, see Item 4.
31 Card standards
PCMCIA (Personal Computer Memory Card International
Association)
PC Card standard Release 2.1, PCMCIA PC Card ATA Release 1.02
32 Card type
PCMCIA TYPE I and TYPE II
33 Card operation mode
PCATA specification
34 Operating voltage of cards
Cards operable only on 5 V and cards operable on 5 V and 3.3 V
(automatic switching)
4 Flash ATA cards of which operation has been checked
As of April in 1999, FANUC had confirmed the operation of the
following cards on the Power Mate i. (These cards support
automatically switching between 5 V and 3.3 V.)
ATA card

Leave a Reply

Your email address will not be published. Required fields are marked *