FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

F. MEMORY CARD INTERFACE
B63173EN/03
APPENDIX
500
1) When a flash ATA card is used for data input/output (for data saving
and restoration)
Manufacturer Model number Capacity Remarks
Hitachi, Ltd.
HB286008A3 8MB
Production
HB286015A3 15MB
discontinued
HB286030A3 30MB
HB286045A3 45MB
HB289016A4 16MB
Under volume
HB289032A4 32MB
production
HB289048A4 48MB
Matsushita Electric
BN012AB 12MB
Industrial Co., Ltd.
BN020AB 20MB
BN040AB 40MB
SanDisk Co.
SDP3B20 20MB
Production
SDP3B40 40MB
discontinued
NOTE
1 For other than the above cards, FANUC has not checked
operation.
2 The above flash ATA cards support automatic switching
between 5 V and 3.3 V.
3 Cards operable only on 3.3 V cannot be used.
4 When a manufacturer changes the specification of a card
listed above, the operation of the card can be disabled.
CAUTION
When an ATA flash card is used with a Power Mate CNC
other than the Power Mate iD/H, the CNC itself or the card
may be damaged electrically. Therefore, although an ATA
flash card can be physically inserted into the PCMCIA card
interface of Power Mate CNCs other than the Power Mate
iD/H, be very careful not to insert the ATA flash card by
mistake.

Leave a Reply

Your email address will not be published. Required fields are marked *