FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
F. MEMORY CARD INTERFACE
APPENDIX
503
1. Overview
With the PCMCIA card interface of the LCD with a touch panel that
supports the display link, some types of SRAM memory cards and
flash ATA cards can be used.
Files such as CNC parameter files, offset data files, and part program
files can be transferred from a card by using the PCMCIA card
interface of the LCD with a touch panel that supports the display link.
NOTE
1 Functions available with the PCMCIA card interface of the
LCD with a touch panel differ from the functions available
with the PCMCIA card interface of the CNC.
2 Cards that can be used with the PCMCIA card interface of
the LCD with a touch panel are not necessarily the same as
the cards usable with the PCMCIA card interface of the
CNC.
3 Some files such as a file of touch panel screen data cannot
be transferred using this interface.
2. Supported software editions
The supported software editions are as follows:
Series Edition
System software
88E0 13 or later
88F1 05 or later
Boot software 881I 09 or later
3 Flash ATA card specifications
A flash ATA card to be used must meet the following standards, types,
and conditions.
Note that all flash ATA cards that satisfy the following requirements
do not always ensure operation.
For the cards FANUC has checked the card operation, see Item 4.
31 Card standards
PCMCIA (Personal Computer Memory Card International
Association)
PC Card standard Release 2.1, PCMCIA PC Card ATA Release 1.02
32 Card type
PCMCIA TYPE I and TYPE II
33 Card operation mode
PCATA specification
34 Operating voltage of cards
Cards operable only on 5 V and cards operable on 5 V and 3.3 V
(automatic switching)
F.2
LCD WITH A TOUCH
PANEL

Leave a Reply

Your email address will not be published. Required fields are marked *