FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

F. MEMORY CARD INTERFACE
B63173EN/03
APPENDIX
504
35 Conditions of cards usable with the LCD with a touch panel that
supports the display link
S The memory map mode must be supported.
S Variable waits must not occur.
S The address access time must be 250 ns or less.
4 Cards of which operation has been checked
As of December in 2000, FANUC had confirmed the operation of the
following cards with the LCD with a touch panel:
1) SRAM memory cards
Manufacturer Model number Capacity Remarks
Fujitsu Media
MB98A9102320 1MB
Not suitable for
Device Co., Ltd.
MB98A9112320 2MB
data backup
2) Flash ATA cards
Manufacturer Model number Capacity Remarks
Hitachi, Ltd.
HB286008A3 8MB
Production
HB286015A3 15MB
discontinued
HB286030A3 30MB
HB286045A3 45MB
HB289016A4 16MB
Under volume
HB289032A4 32MB
production
HB289048A4 48MB
Matsushita Electric
BN012AB 12MB
Industrial Co., Ltd.
BN020AB 20MB
BN040AB 40MB
SanDisk Co.
SDP3B20 20MB
Production
SDP3B40 40MB
discontinued
NOTE
1 For other than the above cards, FANUC has not checked
operation.
2 The above flash ATA cards support automatic switching
between 5 V and 3.3 V.
3 Cards operable only on 3.3 V cannot be used.
4 When a manufacturer changes the specification of a card
listed above, the operation of the card can be disabled.
5 Flash memory cards cannot be used.

Leave a Reply

Your email address will not be published. Required fields are marked *