FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

G. CONNECTING TWO CRT/MDI UNITS
B63173EN/03
APPENDIX
510
6) Cable J148
Key signal cable connected between JA2 on the CRT control PC board
and M3S on the CRT/MDI selection circuit.
CRT control PC board CRT/MDI selection circuit
NOTE) Pins 18 to 20 are not switchable.
Cable connection (J148) The maximum allowed total length of J148 and J149 is 50 m.
Shield
Recommended wire:
A66L00010284#10P (#28AWG10 paired)

Leave a Reply

Your email address will not be published. Required fields are marked *