FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
G. CONNECTING TWO CRT/MDI UNITS
APPENDIX
511
7) Cable J149
Key signal cable connected between CK1 on the CRT/MDI and M3A
or M3B on the CRT/MDI selection circuit.
CRT/MDI selection circuit
NOTE) Pins 18 to 20 are not switchable.
Cable connection (J149) The maximum allowed total length of J148 and J149 is 50 m.
Shield
Recommended wire:
A66L00010284#10P (#28AWG10 paired)

Leave a Reply

Your email address will not be published. Required fields are marked *