FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

G. CONNECTING TWO CRT/MDI UNITS
B63173EN/03
APPENDIX
514
10) Cable J152
Signal selection cable connected between the CRT/MDI selection
switch and SW on the CRT/MDI selection circuit.
CRT/MDI
selection
switch
CRT/MDI selection circuit
Cable connection (J152)
Contact
or
Recommended wire: At least 30/0.18 (0.8 mm
2
). The cable length must be 10 m or less.
Relationships between selection switch settings and selected CRT/MDI
units
Contact CRT/MDI selected
Open CRT/MDI#1
Closed CRT/MDI#2

Leave a Reply

Your email address will not be published. Required fields are marked *