FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

H. SHARING THE CRT/MDI WITH
ANOTHER CNC
B63173EN/03
APPENDIX
520
Power
Mate i
JD41
J45,
J142
JD13
JD47
JD12
JN1
JA1
JA2
CPD1
JA1
JA2
CP5
J136
J72
J145
J154
J136
J172
J153
JA1A
JA2A
CP5OUT
SW
JA1B
JA2B
CP5IN
JA1S
JA2S
J53
J72
CN1
CK1
CN2
J56
CRT/MDI
16/18/21
CRT control
PC board
Power Mate
selection
switch
Power Mate/NC
selection switch
CRT/MDI
selection circuit
1) Cables J45 and J142
Display link cables connected between the Power Mate and CRT
control PC board. For details, see Subsections 8.1.2 and 8.1.3.
2) Cable J47
Device selection switch interface cable connected between the power
mate selection switch and CRT control PC board. For details, see
Subsection 8.1.4.
3) Cable J53
Video signal cable connected between the CRT/MDI selection circuit
and CRT/MDI. For details, see Subsection 8.2.2. The maximum
allowed total length of J53 and J136 is 50 m.
4) Cable J56
Power cord connected between the CRT control PC board and
CRT/MDI. For details, see Subsection 8.2.2.
5) Cable J136
Video signal cable connected between the CRT control PC board or
FANUC series 16, 18, or 21 and the CRT/MDI selection circuit. For
details, see Subsection 8.4.2.
6) Cable J145
Power cord connected between the CRT/MDI selection circuit and
CRT control PC board. For details, see Subsection 8.1.5. (Read the
Power Mate as the CRT/MDI selection circuit. Also read the
CRT/MDI unit as the CRT control PC board.)
H.2
CONNECTION

Leave a Reply

Your email address will not be published. Required fields are marked *