FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
H. SHARING THE CRT/MDI WITH
ANOTHER CNC
APPENDIX
521
7) Cable J72
Key signal cable connected between JA2A on the CRT/MDI selection
circuit and JA2 on the CRT control PC board, between JA2B on the
CRT/MDI selection circuit and JA2 on the FANUC series 16, 18, 21,
or between the JA2S on the CRT MDI selection circuit and CK1 on
the CRT/MDI.
CRT/MDI selection circuit
PCRE20FS
or
PCRE20FA
housing
PCRV20LA
CRT control PC board, 16/18/21, CRT/MDI
Cable connection (J72) The maximum allowed total length of two J72 cables is 50 m.
Shield
Recommended wire: A66L00010284#10P (#28AWG10 paired)

Leave a Reply

Your email address will not be published. Required fields are marked *