FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
H. SHARING THE CRT/MDI WITH
ANOTHER CNC
APPENDIX
523
9) Cable J154
Selection signal cable connected between the Power Mate/NC
selection switch and SW on the CRT/MDI selection circuit.
Power Mate/NC
selection switch
PCRE20FS
or PCRE20FA
housing PCRV20LA
CRT/MDI selection circuit
Cable connection (J154)
Contact
or
Recommended wire: At least 30/0.18 (0.8 mm
2
). The cable length must be 10 m or less.
Relationships between selection switch settings and selected connectors
Contact Connector selected
Open Side A (JA1A or JA2A)
Closed Side B (JA1B or JA2B)

Leave a Reply

Your email address will not be published. Required fields are marked *