FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

INDEX
B63173EN/03
i3
Interface cable, 490
Interface of the external pulse generator (for Power Mate iH),
394
ƠKơ
Keeping the handy operators panel connected at all times, 298
Keyboard, 241
ƠLơ
Labels, 285
LCD with a touch panel, 503
LCD/MDI, standalone type LCD, and standalone type MDI
interface, 252
ƠMơ
Machine interface, 69, 79, 200
Machine interface I/O, 53
Main functions, 413
Main specifications, 342
Manual pulse generator connection, 119, 147, 163
Manual pulse generator interface, 391
Materials for cable assemblies, 471
Maximum number of units that can be connected, 335
Measures against surges due to lightning, 24
Memory card interface, 494
Module installation, 123
Momentary power failure, 43
Mounting, 194, 332
Mounting and dismounting modules, 171
ƠNơ
Noise suppressor, 20
Notes, 359
Notes on cables, 284
Notes on use, 369
Number of points for I/O UnitMODEL A, 182
ƠOơ
Omitting units, 128
Optical fiber cable, 480
Outer dimensions, 170
Outline Drawing, 359
Outline drawing, 285, 312
Output signal specifications, 63
Outside dimensions, 330
Overall connection diagram, 137, 154
ƠPơ
PANEL i, 208
Parameter setting, 360
Position coder interface, 341
Power connection, 138, 155
Power connection diagrams of systems containing the Power
Mate i, 39
Power connections, 44
Power Mate i, 417
Power Mate i main body, 495
Power Mate setting, 299
Power supply and heat loss, 357
Power supply capacity, 357
Power supply for CNC control units, 9
Power supply interface, 239
Power supply unit connection, 34
Poweroff sequence, 42
Poweron sequence, 41
Pressmount type connector assembly tools and jigs, 470
PROFIBUSDP board, 222
Protection ground connection, 44
Protection sheet for the touch panel, 314
ƠRơ
Recommended connectors, applicable housings, and cables,
469
RS232C interface specification, 371
RS232C serial port specification, 378
ƠSơ
Selection switch SW1, 358
Separate detector interface unit, 320
Separating signal lines, 16
Servo check boards, 369
Servo interface (FSSB), 317
Servo/spindle, 418
Sharing a servo amplifier, 318
Sharing of a manual pulse generator by the twopath Power
Mate iD, 396
Sharing the CRT/MDI with another CNC, 518
Signal list, 78
Signals, 68, 199
Specification, 184
Specifications, 130, 148, 164, 191, 258, 272, 308
Specifications and circuit configuration of external 24VDC
power supply, 35

Leave a Reply

Your email address will not be published. Required fields are marked *