FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)


FANUC LTD

 .

2/
4

FANUC Power Mate i-MODEL D/H
Connection MANUAL
Hardware
The connection of DPL/MDI
B-63173EN/03-01
Section 8.10 is added the connection manual of
FANUC Power Mate i-MODEL D/H.
8.10 The connection of the DPL/MDI
8.10.1 Outline
The dust-proof DPL/MDI is available for Power Mate i-D/H.
The DPL/MDI adapter or suitable things are necessary to connect with the DPL/MDI.
The connection tap of DPL/MDI should be prepared at the cabinet to connect the DPL/MDI.
It is not possible to connect and disconnect at the connector JD40.
8.10.2 DPL/MDI adapter
The connector of the cable J6 is 15-pin D-SUB connector. The connector of the Power Mate
i
is 20 pin
PCR connector. The DPL/MDI adapter is for the changing 20-pin PCR connector to 15-pin D-SUB
connector. The DPL/MDI adapter is like a punch panel of RS-232-C. Please refer to the figure 18
“punch panel (for 1 channel)” of the connection manual appendix A for the DPL/MDI adapter
The following DPL/MDI adapters are prepared by FANUC.
Specification Length Resistance of the
cable
A02B-0259-C201 1m 0.074
A02B-0259-C202 2m 0.15
A02B-0259-C202 5m 0.37
Cabinet
FANUC Power
Mate
i
-MODEL
D/H
JD40
J161
DPL/MDI adapter
J6
DPL/MDI Cable
DPL/MDI

Leave a Reply

Your email address will not be published. Required fields are marked *