FANUC Power Mate i-MODEL H CONNECTION MANUAL (HARDWARE)

B63173EN/03
5. POWER SUPPLY UNIT CONNECTION
47
(4)Remove the old battery from the top of the Power Mate control unit.
First unlatch the battery, remove it from the battery holder, and detach
its connector. The battery holder is on top of the face plate (or the
memory connector) on the base printedcircuit board.
Battery latch
Lithium
battery
Battery
connector
(5)Remove the old battery, insert a new one into the battery holder, and
attach the connector. Confirm that the battery is latched firmly.
WARNING
Using other than the recommended battery may result in the
battery exploding.
Replace the battery only with the specified battery
(A02B0200K102).
CAUTION
1 Before replacing the battery, check that the latest data of the
SRAM memory is already backed up.
2 Turn off the power to the machine before replacing the battery.
Only personnel trained in maintenance and safety can replace
the battery when the power to the machine is on.
3 Complete steps (3) to (5) above within 30 minutes
. If the
battery is detached for a long time, the contents of the
SRAM memory are lost.

Leave a Reply

Your email address will not be published. Required fields are marked *