Fanuc Series 15i/150i-MA (Programming) Operators Manual

4.INTERPOLATION FUNCTIONS PROGRAMMING B-63324EN/03
- 104 -
Limitation
- Modes not allowed
Before specifying G06.1, cancel canned cycle mode, tool offset mode,
and cutter compensation mode if these modes are set.
- First block of the subprogram
Specify a move command in the first block of the subprogram to be
called in the spline interpolation mode.
<Example> O1000; O1000 X_ Y_ Z_ ;

Leave a Reply

Your email address will not be published. Required fields are marked *