Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 4.INTERPOLATION FUNCTIONS
- 139 -
(Travel distance along a NURBS curve. This distance does not
always represent a travel distance if a rotation axis is
involved.)
The format of F code is F4.3 (0.001 to 9999.999) as with the ordinary
inverse time command. The valid data range of a feedrate command is
the same as for a feedrate command in the feed per minute mode.
NOTE
The actual operation time may slightly vary from a
specified time due to CNC internal processing.

Leave a Reply

Your email address will not be published. Required fields are marked *