Fanuc Series 15i/150i-MA (Programming) Operators Manual

4.INTERPOLATION FUNCTIONS PROGRAMMING B-63324EN/03
- 142 -
- Polar coordinate interpolation
- Polar coordinate command
- Normal direction control
- Hypothetical axis interpolation
- Cylindrical interpolation
- Drilling canned cycle/electronic gearbox
- Modal call
- Exact stop mode
- Automatic corner override
- Tapping mode
- Chopping
- Interrupt-type custom macro
- Unidirectional positioning
- Dwell
- Miscellaneous functions (except M00/M01/M02/M30)
- Data setting (G10)
- Reference position return function
- Skip function, multistage skip
- Tool length automatic measurement
- Macro call
- Linear copy
- Rotational copy
- Exact stop
- Machine coordinate system selection
- Workpiece coordinate system setting
- Workpiece coordinate system selection/workpiece
- coordinate system setting
- Workpiece coordinate system preset
- Local coordinate system preset
- Optional-angle chamfering/corner rounding
- Modes in which this function cannot be specified
This function cannot used in the modes of the following functions:
- Functions related to cutter radius compensation
(group 07)
- 3-dimensional coordinate conversion
- Coordinate system rotation
- Scaling
- Programmable mirror image
- Polar coordinate interpolation
- Polar coordinate command
- Normal direction control
- Hypothetical axis interpolation
- Cylindrical interpolation
- Drilling canned cycle/electronic gearbox
- Modal call
- Exact stop mode
- Automatic corner override
- Tapping mode
- Chopping

Leave a Reply

Your email address will not be published. Required fields are marked *