Fanuc Series 15i/150i-MA (Programming) Operators Manual

TABLE OF CONTENTS B-63324EN/03
c-4
10TOOL FUNCTION (T FUNCTION).....................................................................242
10.1 TOOL SELECTION FUNCTION ................................................................243
10.2 TOOL LIFE MANAGEMENT FUNCTION ..................................................244
10.2.1 Tool Life Management Data................................................................................ 245
10.2.2 Register, Change and Delete of Tool Life Management Data ............................ 246
10.2.3 Tool Life Management Command in a Machining Program............................... 249
10.2.4 Tool Service Life Count and Tool Selection....................................................... 254
10.2.5 Tool Life Count Restart M Code......................................................................... 256
11 AUXILIARY FUNCTION .....................................................................257
11.1 AUXILIARY FUNCTION (M FUNCTION)...................................................258
11.2 MULTIPLE M COMMANDS IN A SINGLE BLOCK....................................260
11.3 THE AUXILIARY FUNCTIONS ..................................................................261
12 PROGRAM CONFIGURATION ..........................................................262
12.1 PROGRAM SECTION CONFIGURATION ................................................264
12.2 SUBPROGRAM (M98, M99)......................................................................270
12.3 PROGRAM NUMBER................................................................................274
12.4 PROGRAM COMPONENTS OTHER THAN PROGRAM SECTIONS.......275
12.5 EXTERNAL DEVICE SUBPROGRAM CALL (M198) ................................278
13 FUNCTIONS TO SIMPLIFY PROGRAMMING...................................280
13.1 CANNED CYCLE.......................................................................................281
13.1.1 High-speed Peck Drilling Cycle (G73)................................................................ 287
13.1.2 Left-handed Tapping Cycle (G74) ...................................................................... 289
13.1.3 Fine Boring Cycle (G76)..................................................................................... 292
13.1.4 Drilling Cycle, Spot Drilling (G81)..................................................................... 295
13.1.5 Drilling Cycle Counter Boring Cycle (G82) ....................................................... 297
13.1.6 Peck Drilling Cycle (G83)................................................................................... 299
13.1.7 Tapping Cycle (G84)........................................................................................... 301
13.1.8 Boring Cycle (G85) ............................................................................................. 304
13.1.9 Boring Cycle (G86) ............................................................................................. 306
13.1.10 Boring Cycle/Back Boring Cycle (G87).............................................................. 308
13.1.11 Boring Cycle (G88) ............................................................................................. 313
13.1.12 Boring Cycle (G89) ............................................................................................. 315
13.1.13 Canned Cycle Cancel (G80)................................................................................ 317
13.1.14 Example of Canned Cycle ................................................................................... 318
13.2 RIGID TAPPING ........................................................................................320
13.2.1 Rigid Tapping (G84.2) ........................................................................................ 321

Leave a Reply

Your email address will not be published. Required fields are marked *