Fanuc Series 15i/150i-MA (Programming) Operators Manual

5.FEED FUNCTIONS PROGRAMMING B-63324EN/03
- 162 -
Format
Exact stop G09 IP ;
Exact stop mode G61;
Cutting mode G64;
Tapping mode G63;
Automatic corner override G62;
5.5.1 Exact Stop (G09, G61)Cutting Mode (G64)Tapping Mode (G63)
Explanation
The inter-block paths followed by the tool in the exact stop mode, cutting
mode, and tapping mode are different (
Fig.5.5.1 (a)).
Fig.5.5.1 (a) Example of Tool Paths from Block (1) to Block (2)
Tool path in the cutting mode or tapping mode
Tool path in the exact stop mode
Position check
(1)
(2)
Y
0
X
CAUTION
The cutting mode (G64 mode) is set at power-on or
system clear.

Leave a Reply

Your email address will not be published. Required fields are marked *