Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 5.FEED FUNCTIONS
- 165 -
Fig.5.5.2 (d) Override Range (Straight Line to Arc, Arc to Straight Line)
- Override value
An override value is set with parameter No. 6612. An override value is
valid even for dry run and F1-digit specification.
In the feed per minute mode, the actual feedrate is as follows:
F×(automatic override for inner corners) × (feedrate override)
Limitation
- Start-up/G41, G42
Override for inner corners is disabled if the corner is preceded by a
start-up block or followed by a block including G41 or G42.
- Offset
Override for inner corners is not performed if the offset is zero.
Cutter center path
da
LsLe
b
Programmed path
Tool
Ls
Le
(2)
C

Leave a Reply

Your email address will not be published. Required fields are marked *