Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 5.FEED FUNCTIONS
- 171 -
NOTE
1 The machine lock or interlock function sometimes
does not work as soon as the corresponding switch
is turned on while the automatic clamp function is
being executed.
2 If the feed hold switch is turned on while the
automatic clamp function is being executed, the
feed hold is accepted, and the SPL signal
(automatic operation hold) is output. In this case,
however, the tool sometimes does not stop
immediately.

Leave a Reply

Your email address will not be published. Required fields are marked *