Fanuc Series 15i/150i-MA (Programming) Operators Manual

7.COORDINATE SYSTEM PROGRAMMING B-63324EN/03
- 190 -
7.2 WORKPIECE COORDINATE SYSTEM
A coordinate system used for machining a workpiece is referred to as a
workpiece coordinate system.
A workpiece coordinate system can be set using one of the two methods
described below.
(1) Method using G92
A workpiece coordinate system is set by specifying a value after
G92 in the program.
(2) Method using G54 to G59
Six workpiece coordinate systems are set in advance, based on
settings made from the MDI panel, and the desired workpiece
coordinate system is selected according to programmed
commands G54 to G59.

Leave a Reply

Your email address will not be published. Required fields are marked *