Fanuc Series 15i/150i-MA (Programming) Operators Manual

7.COORDINATE SYSTEM PROGRAMMING B-63324EN/03
- 206 -
7.5 PLANE CONVERSION FUNCTION
This function converts a machining program created on the G17 plane
in the right-hand Cartesian coordinate system to programs for other
planes specified by G17.1Px commands, so that the same figure
appears on each plane when viewed from the directions indicated by
arrows.
Z
X
G17.1P4
G17.1P3
G17.1P1 (G17)
G17.1P2
G17.1P5
Format
G17.1 P_ ;
P_ : P1 to P5 Plane conversion specification
Explanation
The plane conversion for a machining figure on the G17 plane is
performed as follows:
(1)
Y
X
G17.1 P1
G17 plane
Z
indicates that the positive direction of the axis perpendicular to the
page is the direction coming out of the page (in this case, the Z-axis
perpendicular to the XY plane).

Leave a Reply

Your email address will not be published. Required fields are marked *