Fanuc Series 15i/150i-MA (Programming) Operators Manual

8.COORDINATE VALUE AND DIMENSION PROGRAMMING B-63324EN/03
- 212 -
8 COORDINATE VALUE AND DIMENSION
This chapter contains the following topics.
8.1 ABSOLUTE AND INCREMENTAL PROGRAMMING
(G90, G91)
8.2 POLAR COORDINATE COMMAND (G15, G16)
8.3 INCH/METRIC CONVERSION (G20, G21)
8.4 DECIMAL POINT INPUT/
POCKET CALCULATOR TYPE DECIMAL POINT INPUT
8.5 DIAMETER AND RADIUS PROGRAMMING
8.6 PROGRAMMABLE SWITCHING OF DIAMETER/RADIUS
SPECIFICATION

Leave a Reply

Your email address will not be published. Required fields are marked *