Fanuc Series 15i/150i-MA (Programming) Operators Manual

9.SPINDLE SPEED FUNCTION (S FUNCTION) PROGRAMMING B-63324EN/03
- 224 -
9.1 SPECIFYING THE SPINDLE SPEED WITH A CODE
When a value is specified after address S, the code signal and strobe
signal are sent to the machine to control the spindle rotation speed.
A block can contain only one S code.
Refer to the appropriate manual provided by the machine tool builder
for details such as the number of digits in an S code or the execution
order when a move command and an S code command are in the same
block.

Leave a Reply

Your email address will not be published. Required fields are marked *