Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 9.SPINDLE SPEED FUNCTION (S FUNCTION)
- 241 -
- System with more than one spindle
In a system with more than one spindle, spindle speed fluctuation
detection is performed for the spindle described below.
1) If the system has no spindle control switching function
Spindle speed fluctuation detection is performed for the first
spindle.
2) If the system has a spindle control switching function
Spindle speed fluctuation detection is performed for the spindle
selected in spindle control switching.
Spindle speed fluctuation detection is not performed for a spindle
that is not selected in spindle control switching.

Leave a Reply

Your email address will not be published. Required fields are marked *