Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 10.TOOL FUNCTION (T FUNCTION)
- 243 -
10.1 TOOL SELECTION FUNCTION
By specifying an up to 10-digit numerical value following address T,
tools can be selected on the machine.
One T code can be commanded in a block.
Refer to the machine tool builder’s manual for the number of digits
commandable with address T and the correspondence between the T
codes and machine operations.
When a move command and a T code are specified in the same block,
the commands are executed in one of the following two ways:
(i) Simultaneous execution of the move command and T function
commands.
(ii) Executing T function commands upon completion of move
command execution.
The selection of either (i) or (ii) depends on the machine tool builder’s
specifications.

Leave a Reply

Your email address will not be published. Required fields are marked *