Fanuc Series 15i/150i-MA (Programming) Operators Manual

10.TOOL FUNCTION (T FUNCTION) PROGRAMMING B-63324EN/03
- 246 -
10.2.2 Register, Change and Delete of Tool Life Management Data
In a program, tool life management data can be registered in the CNC
unit, and registered tool life management data can be changed or
deleted.
Explanations
A different program format is used for each of the four types of
operations described below.
- Register with deleting all groups
After all registered tool life management data is deleted, programmed
tool life management data is registered.
- Addition and change of tool life management data
Programmed tool life management data for a group can be added or
changed.
- Deletion of tool life management data
Programmed tool life management data for a group can be deleted.
- Register of tool life count type
Count types (time or frequency) can be registered for individual
groups.
Format
- Register with deleting all groups
Format Meaning of command
G10L3;
P-L-;
T-H-D-;
T-H-D-;
:
P-L-;
T-H-D-;
T-H-D-;
:
G11;
M02(M30);
G10L3:Register with deleting all groups
P-: Group number
L-: Life value
T-: Tool number
H-: Code specifying tool offset value (H code)
D-: Code specifying tool offset value (D code)
G11: End of registration

Leave a Reply

Your email address will not be published. Required fields are marked *