Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 10.TOOL FUNCTION (T FUNCTION)
- 247 -
- Addition and change of tool life management data
Format Meaning of command
G10L3P1;
P-L-;
T-H-D-;
T-H-D-;
:
P-L-;
T-H-D-;
T-H-D-;
:
G11;
M02(M30);
G10L3P1: Addition and change of group
P-: Group number
L-: Life value
T-: Tool number
H-: Code specifying tool offset value (H code)
D-: Code specifying tool offset value (D code)
G11: End of addition and change of group
- Deletion of tool life management data
Format Meaning of command
G10L3P2;
P-;
P-;
P-;
P-;
:
G11;
M02(M30);
G10L3P2: Deletion of group
P-: Group number
G11: End of deletion of group
- Setting a tool life count type for groups
Format Meaning of command
G10L3
(or G10L3P1);
P-L-Q-;
T-H-D-;
T-H-D-;
:
P-L-Q-;
T-H-D-;
T-H-D-;
:
G11;
M02(M30);
Q: Life count type
(1:Frequency, 2:Time)
CAUTION
When the Q command is omitted, the value set in bit
3 (LTM) of parameter No.7400 is used as the life
count type.

Leave a Reply

Your email address will not be published. Required fields are marked *