Fanuc Series 15i/150i-MA (Programming) Operators Manual

10.TOOL FUNCTION (T FUNCTION) PROGRAMMING B-63324EN/03
- 252 -
- Tool change methods B and C
A tool group command (T code) specified in a block containing the tool
change command (M06) functions as a tool group number command
that performs life counting with the next tool change command.
Example: Assume that the tool life management ignore number is 100.
T101 ; Selects a group 1 tool whose service life has not expired.
: (Assume that tool number 100 is selected.)
M06 T102 ; Counts the service life of a tool of group 1.
: (The service life counting of tool number 010 starts.)
: Selects a group 2 tool whose service life has not expired.
: (Assume that tool number 100 is selected.)
M06 T103 ; Counts the service life of a tool of group 2.
: (The service life counting of tool number 100 starts.)
: Selects a group 3 tool whose service life has not expired.
: (Assume that tool number 200 is selected.)
G43 H99 ; Uses tool length compensation for the tool selected from group 2.
:
G41 D99 ; Uses cutter compensation for the tool selected from group 2.
:
D00 ; Cancels cutter compensation.
:
H00 ; Cancels tool length compensation.
:
M06 T104 ; Counts the service life of a tool of group 3.
: (The service life counting of tool number 200 starts.)
: Selects a group 4 tool whose service life has not expired.
NOTE
When a tool group number command is specified
singly in a block, method B must generally be used.
When a tool group number command is specified
singly in a block according to method C, however, no
alarm is issued.

Leave a Reply

Your email address will not be published. Required fields are marked *