Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 13.FUNCTIONS TO SIMPLIFY PROGRAMMING
- 317 -
13.1.13 Canned Cycle Cancel (G80)
G80 cancels canned cycles.
Format
G80 ;
Explanation
All canned cycles are canceled to perform normal operation.
This means that R = 0 and Z = 0 in incremental mode. Other drilling
data is also canceled (cleared).
Example
M3 S100 ; Cause the spindle to start rotating.
G90 G99 G88 X300. Y-250. Z-150. R-120. F120. ;
Position, drill hole 1, then return to point R.
Y-550. ; Position, drill hole 2, then return to point R.
Y-750. ; Position, drill hole 3, then return to point R.
X1000. ; Position, drill hole 4, then return to point R.
Y-550. ; Position, drill hole 5, then return to point R.
G98 Y-750. ; Position, drill hole 6,
then return to the initial level.
G80 G28 G91 X0 Y0 Z0 ; Return to the reference position return,
canned cycle cancel
M5 ; Cause the spindle to stop rotating.

Leave a Reply

Your email address will not be published. Required fields are marked *