Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 13.FUNCTIONS TO SIMPLIFY PROGRAMMING
- 321 -
13.2.1 Rigid Tapping (G84.2)
When the spindle motor is controlled as if it were a servo motor, a
tapping cycle can be sped up.
The only difference from the reverse rigid tapping cycle (G84.3) is the
spindle rotation direction in tapping.
Format
Explanation
After positioning along the X- and Y-axes, rapid traverse is performed
to point R.
Tapping is performed from point R to point Z. When tapping is
completed, the spindle is stopped and a dwell is performed . The
spindle is then rotated in the reverse direction, the tool is retracted to
point R, then the spindle is stopped. Rapid traverse to initial level is
then performed for G98.
While tapping is being performed, the feedrate override and spindle
override are assumed to be 100%.
However, the speed for extraction (operation 5) can be overridden by
up to 200% depending on the setting at parameter No.5883.
G84.2(G98) G84.2(G99)
G84.2 X_ Y_ Z_ R_ P_ F_ L_ S_ ;
X_ Y_: Hole position data
Z_ : The distance from point R to the bottom of the hole and the position of
the bottom of the hole
R_ : The distance from the initial level to point R level
P_ : Dwell time at the bottom of the hole and at point R when a return is
made
F_ : Cutting feedrate
L_ : Number of repeats (Only for necessity of repeat)
Initial level
Point R
Spindle
stop
Spindle CW
Point Z
P
Point R level
Operation2
Operation1
Operation6
Operation3
Operation4
Operation5
Spindle stop
Spindle CCW
Point R
Spindle CW
Point Z
P
Point R level
Spindle stop Spindle CCW
Spindle stop
Spindle stop
Spindle stop
P
S_ : Spindle speed

Leave a Reply

Your email address will not be published. Required fields are marked *