Fanuc Series 15i/150i-MA (Programming) Operators Manual

B-63324EN/03 PROGRAMMING 1.GENERAL
- 13 -
Symbols of the programmed commands G01, G02, ... are called the
preparatory function and specify the type of interpolation conducted in
the control unit. B
Fig.1.1 (c) Interpolation function
NOTE
Some machines move tables instead of tools but this
manual assumes that tools are moved against
workpieces.
H
(a) Movement along straight line (b) Movement along arc
G01Y ; G03X Y
R ;
X Y ;
bmb
Tool move-
ment
Y axis
X axis
IInterpolation
a) Movement
along straight ine
b) Movement
along arc

Leave a Reply

Your email address will not be published. Required fields are marked *